The stator winding machine is used for winding the copper wire into the stator or make the coils and embed into the stator. Stator manufacturing equipment has different types such as stator needle winding, stator wave winding and electric wheel hub motor stator according to different application range. Stranded wire winding machine and so on.
Brushless motor because of its high efficiency, low power consumption, low noise, long life, high reliability, servo control, stepless frequency control, relatively low cost and easy to use, is becoming a trend, brushless motor recommended Using WIND-TSM series of needle-winding machine, the use of servo precision positioning, can automatically complete the first automatic winding head tail, automatic winding, automatic cable, automatic indexing, automatic clip wire, automatic stripping and other actions , And for different winding design of the stator and the output requirements with the most economical brushless motor stator winding machine.
Wheel motor is generally used in the voltage of 24V, 36 \ V, 48V, 62V electric bicycle, the wheel motor is generally multi-stranded wire winding at the same time, it is recommended for wheel hub type Flying-type multi-strand wires winding machine. The device is equipped with two winding stations, can be wound at the same time two stator. The machine adopts the servo motor control system to realize the product winding system. The man-machine interface has the functions of fault diagnosis, output quantity storage and so on. It can set automatic winding, multi-wire winding, automatic indexing, automatic slotting and winding speed,parameter setting.
Fan motor, you can use a dedicated fan winding machine.
The economic type WIND-FW-2 uses dual-bit institutions, controlled by the microcomputer, can be automatically wound, automatic cable, automatic indexing. One cable and sub-degree stepper motor control, winding by the inverter motor control. Turns can be accurate to 0.1 turns.
The popular type WIND-CFW-4 four station ceiling fan winding machine is for mass production with inner coils and outside coils winding in a four station machine with servo system. (One Pakistan big plant purchase over 20pcs this type machine)
It is recommended to use the vertical stator automatic winding machine WIND-100-VW for the stator with high output requirement. It is efficient and saves copper wire and aluminum wire. The equipment can arrange the coil neatly to the hanging cup, which is especially suitable for high output requirement. Slot full rate, small slot stator winding.
For economic type we recommend the use of CNC coil winding making machine WIND-160-HW, the device can be used for multi-connected, multi-layer coil winding system can be a while around 1 to 4 sets of coils
For larger and heavier stator, it is recommended to use high-power winding machine, around the end of the line after the mold can be automatically retracted, without removing the coil to take off the mold, greatly reducing the labor intensity and improve work efficiency.
For the 2-pole stator, the highest degree of automation is the WIND-ASW-2 stator winder, which automatically winds the wire into the stator slots and allows the machine to automatically load and unload.
Pearl
Emily